Here are some of the quality used drilling rigs that we currently have available. These are largely first-line rigs that will generate the same daily revenues that a brand new rig will, but without the high capital cost that a new rig will require. We can also assist you with low-cost financing. If you are contemplating adding a rig, please see which one of these will meet your needs. Then call us; we'll be glad to get you more detailed information and photos. If you'd rather, we can repair or fully remanufacture one of you existing rigs too. Either way, just give us a call - we'll be glad to work with you any way we can!

Used Rigs

B53 on MOROOKA ATV CARRIER Code: B53-MOROOKA Price: $95,000.00 Quantity in Basket: none MOBILE DRILL B-53 ON MOROOKA RUBBER-TRACKED ATV CARRIER, EQUIPPED WITH: Fully remanufactured by us in February, 2007. This included: - Replacing all decking - Rebuilding all hydraulic cylinders - Rebuilding all valve banks - New hydraulic pump - Rebuilding right angle drive, transmission, and PTO - Replacing all hydraulic hoses with Parker "Tough Cover" hoses - Sandblasting and painting while disassembled, prior to rehosing - Adding an in/out slidebase - Rebuilding crown block - Replacing all worn components in mast hinge assembly - Installing on Morooka MST-800 rubber-tracked ATV carrier Please note that photos are of rig when we had just completed remanufacturing it. Current photos expected soon, but know that the rig looks essentially identical except for a few nicks and scratches in the paint and some slight fading. This rig and carrier combination makes an excellent low-impact unit that will go almost anywhere. The Morooka's hydrostatic drive is extremely reliable; much more so than mechanical drives. This unit is available immediately, and can be seen in operation or tested by appointment. Please call Drew at 800-447-2425, or email me at drew@earthx.com with any questions.

2000 DAVEY KENT DK-5 & INT'L TANDEM Code: DAVEY DK-5 Price: $145,000.00 Quantity in Basket: none Completely new hydraulic system with independent pumps for rotation, feed, mud pump, and main hoist. - All four new function pumps are variable displacement piston pumps. - Plus a dedicated filtration and cooling circuit for super clean hydraulic system. - Drillhead performance is 0-77 RPM in low range, with up to 12,100 lbs/ft of torque, and - 0-154 RPM in high range, with up to 6,054 lbs/ft of torque. - Extremely fast retract and pulldown for fast rod pulls. - Large capacity hydraulic rod clamp. - Pullmaster H8 main hoist, with high-speed operation. - Mobile SAF-T-DRIVER hoist for SPT soil sampling. - Newly-rebuilt Gardner-Denver 5x6 piston pump with new drive motor. - Hydraulic cathead. - Moyno 3L6 pump (45 GPM @ 225 PSI). - Gamma piston injection pump. - Cummins 6BTA engine with aftercooler and 165HP. - Slidebase and wiggletail. - Sliding head for easy access to borehole. - Large capacity hydraulic oil cooler with electronic fan speed controller. - Top feed swivel. - Three hdyraulic stabilizer jacks. - New head traveler guides, plus a spare set included with sale. - 250 gallon (approx) capacity water tank. - Two hinging auger racks. This is a great chance to own a thoroughly-updated, high speed rig for mud and auger drilling. The rig has only approximately 4,200 hours since new, and the truck has only about 20,000 miles since new. The rig was delivered with a hydraulic system that rendered it very slow to operate, and its owner relegated it to occasional use only. Hence the low hours and miles. Now, however, we have replaced the original hydraulic system entirely with a piston-pump based system that yields extremely fast operating cycle times. Additionally, the rig is capable of soils sampling and auger work, so will make a fantastic combination rig for owners with a diverse drilling business. We are in the final stages of this refurbishing, and can still add options and customizations. Additionally, while the rig is currently slated to be repainted in safety blue, we are happy to discuss a different color. Please note that the photos in the listing are of the rig in its pre-refurbished condition. As soon as it is painted, we will update the listing with new photos. Please call or email Drew to inquire.

1995 Mobile Drill B-59 & 1995 Ford F-800 Code: B59 Price: $115,000.00 Quantity in Basket: none 1995 Mobile Drill B-59, equipped with: 13,500 lbs/ft of torque Cummins 4BT turbo-diesel deck engine 700 RPM top spindle speed Two-speed right angle drive 30' quick-disconnect mast 8,500 lbs capacity Pullmaster main hoist 4,500 lbs capacity Pullmaster auxiliary hoist 900 lbs capacity Mobile SAFE-T-DRIVER sampling hoist 5,000 lbs capacity cathead Clark 18000 three speed automatic Power Shift transmission 250 gallon water tank with under tank storage compartments Auxiliary air compressor Two hinging auger racks Moyno 3L6 water pump Three 36" hydraulic stabilizer jacks Approximately 2,700 hours and well maintained 1995 Ford F-800, with: Cummins turbo-diesel engine Manual transmission 43,000 original miles (+/-) Dual 50 gallon fuel tanks Second-owner rig that has little time and few miles. Has been well maintained, and is in frequent use. The B59 is great rig to operate; it has a Clark automatic transmission, which is bullet-proof. In the eighteen-odd years that Mobile has been using these trannies, we have never had one come unglued! It also makes operating the rig much easier - no clutch to futz with, and you shift back and forth from forward to reverse with no worries about damage. This rig is extremely tight; there is no wear or play in the usual places. The decking is all solid with no rust through anywhere. Don't let the faded paint concern you; better that you see any used rig the way it is than after someone gives it a five-gallon overhaul. Speaking of which, we can sandblast and paint this rig to match your fleet, too. Available immediately. Please call Drew at 800-447-2425, or email me at drew@earthx.com

1991 MOBILE DRILL B61-HDX & 2000 INT'L 4800 Code: B61-HDX Price: $75,000.00 Quantity in Basket: none 1991 Mobile Drill B61-HDX on 2000 International 4800 4 x 2 Equipped with: 20,000 lbs/ft of torque 3 speed Clark automatic Power Shift transmission 29' Mast 8,500 lbs capacity Pullmaster main hoist 3,200 lbs capacity auxiliary hoist 900 lbs capacity Mobile SAFE-T-DRIVER sampling hoist 2" hex quick-change auger adapter with quill for top feed swivel In/out slidebase Sideways slidebase Four-door tool box Two hinging auger racks 250 gallon water tank with undertank storage compartments Three 36" hydraulic stabilzer jacks Safety hammer storage tube Auxiliary fuel tank Underbody rod storage Hydraulic breakout wrench 2000 International 4800 4 x 2, with: 230HP DT466 turbo-diesel engine Six speed manual transmissionv 51,000 original miles (+/-) 33,000 lbs GVW Tires at 80% condition (+/-) This unit was refurbished by us in October, 2003. It was then sold to its current owner, a family owned and operated two-rig business. Recent mechanical work includes rebuilding the right angle drive and rotary table, and will also include replacement of the main valve bank and rebuilding of the feed cylinders. Rig and truck are in service daily, and available immediately. Please call Drew with any questions at 800-447-2425, or email to drew@earthx.com.

1990 MOBILE B-57 & F-800 DIESEL/DIESEL Code: B-57 Price: $55,000.00 Quantity in Basket: none 1990 MOBILE DRILL B-57, equipped with: Cummins diesel deck engine with 7,850 hours Slide base Wiggle tail Main and aux hoists SAFE-T-DRIVER sampling hoist Water tank Hinging auger racks Three hydraulic jacks 3L4 pump Tool boxes Operator step platform Under tank storage compartment Underbody rod storage compartment for 10' tools Quick-disconnect mast assembly Mounted on a 1990 Ford F-800 with 30,000 lbs GVW Air brakes 210 HP Ford 7.8L turbo-diesel engine Five speed transmission with two-speed rear axle Dual fuel tanks 183,500 miles (+/-)